Use material：sus303

Subordinate industry：Electronic

Technological requirements：the surface finish of 0.8, the round beating 0.005,concentricity 0.01, one-time setup completed car outside diameter, grooving, cut.

Processing equipment：RNC-V15E RNC-V20E can be processed

Use material：Copper

Subordinate industry：Electronic

Technological requirements：surface finish of 0.8, the outer diameter tolerances 0.02one-time setup completed grid slot car outside diameter, grooving, threading, cut off.

Processing equipment：RNC-V15E

Use material：Copper

Subordinate industry：Electronic

Technological requirements：one-time setup to complete the six-sided drilling, tapping,milling, milling side, cut off.

Processing equipment：RNC-V15E

Use material：sus304

Subordinate industry：Electronic

Technological requirements：This part is relatively small, demanding the tool. One-time setup complete car outside diameter, drilling side holes, milling on both sides, cut off.

Processing equipment：RNC-V15E

Use material：POM

Subordinate industry：Electronic Communications industry

Technological requirements：surface finish of 0.8 linear dimensional tolerances of the M-Class, tapping a depth greater than 25 mm, the need turning diameter, drilling andtapping a depth of more than 25mm, milling flat single setup complete.

Processing equipment：RNC-15E RNC-20E can be processed

Use material：Copper

Subordinate industry：Electronic

Technological requirements：the surface finish of 0.8, 0.005 OD tolerance. This partrequires precise, one-time setup complete car drilling, boring, milling concave bit, cut a straight groove milling slot car outside diameter, cut.

Processing equipment：RNC-V15E

Use material：SUS304

Subordinate industry：Electronic (Canon printer)

Technological requirements：parts surface finish of 0.4, the length required secondaryfeeding, tolerance ± 0.02, the slot position tolerance of 0.01, finished slot andgroove diameter 0.02, need turning OD turning slot head arc, outside thread a fixturecompleted.

Processing equipment：RNC-15E RNC-20E can be processed

Use material：Beryllium Copper

Subordinate industry：Electronic Industry

Technological requirements：workpiece surface finish of 0.8, the diameter size tolerance0/-0.02 need turning the OD, processing within the hole, slotted, a fixture completed.

Processing equipment：RNC-15E RNC-20E can be processed